Skip to content

Resource · Privacy limits

Tracking Workers After Hours, on Breaks and in Restrooms: Where It Has to Stop

Location tracking should stop when paid work stops. Do not collect location after the shift, and decide in writing what happens at meal and rest breaks. California's AB 1331, effective January 1, 2027, is reported to bar monitoring employees inside workplace bathrooms and to let them leave devices behind. Test any vendor by checking that nothing arrives after a shift ends.

Last updated By ZeroBadge

This is general information, not legal advice. Laws differ by state and change over time. Check the primary sources below and talk to an employment lawyer about your situation.

Can you track workers when they are off duty?

No, and you should not try. The business reasons for location data end when paid time ends, and off-duty location shows a person's home, doctor and family. A signed consent does not make that a good idea. Decide before rollout that location is collected during scheduled work hours only, and write that in the policy.

The legal frame, including state laws, is in worker location tracking laws. This page covers the three boundaries that cause the most trouble: the end of the shift, breaks and restrooms.

What about meal and rest breaks?

Decide it in writing, and err toward collecting less. An unpaid meal break is time the worker is off duty, so location from that period has little job purpose and more privacy cost. Rest breaks are usually paid, so the call is closer.

  • Say in the disclosure whether the device collects during breaks.
  • Give workers a way to pause location for an unpaid meal break, and say so.
  • Do not use break-time location to question where a worker took a break.
  • Meal and rest break rules differ by state. California, for example, has its own rules, so ask your lawyer which apply to your crews.

What is the restroom rule, and who does it apply to?

Beginning January 1, 2027, California's AB 1331 is reported to prohibit using a workplace surveillance tool to monitor employees inside a workplace bathroom unless a court orders it. The Governor signed it on September 30, 2026. It adds Part 5.8 to the Labor Code, starting at section 1560.

  • Reports say "surveillance tool" is broad enough to include badges and other wearables that report location.
  • Employees may leave a covered device outside before entering a restroom, and employers may not discipline them for doing so.
  • Reported exceptions include employees who must stay available during breaks, a one-time badge swipe to enter or exit, and identification or safety devices that record no audio or video and have no embedded artificial intelligence.
  • Reports describe civil penalties of up to $500 per violation, enforceable by the Labor Commissioner or public prosecutors.
  • In signing, the Governor noted ambiguities, including about locked-door access systems, and asked for follow-up legislation. The text may change.

Even outside California, a restroom policy that lets workers leave the badge behind is easy and avoids a bad day. Write it down and say so on day one. For California specifics, see Penal Code 637.7.

Where does commuting end and paid travel begin?

Ordinary travel from home to the place where the work is done is generally not paid time, but travel between jobsites during the workday generally is. Under 29 CFR 785.38, travel from one job site to another during the workday must be counted as hours worked.

The Portal-to-Portal Act says employers generally are not liable under the FLSA for failing to pay for commuting to and from the place where the principal work is performed, unless a contract or custom makes it compensable. A state can pay more than the federal floor, so check yours.

Which trips are normally inside the tracking window
TripUsually paid time?Location collected?
Home to the first jobsite or shopGenerally no (commute)No, if the shift starts at arrival
Shop to jobsite after reporting inGenerally yesYes, during the shift
Jobsite to supply house to jobsiteGenerally yesYes, during the shift
Last jobsite back to the shop, then homeBack to the shop yes, shop to home noUntil the shift ends
Home in a take-home company vehicleDepends on facts and agreementsSet the rule in writing
General federal rules. State law, agreements and facts can change the answer. See the travel guide below.

More on pay for travel in travel time between job sites and drive time and location data.

How do I set shift windows and test a vendor?

Set the scheduled shift window for each worker, then test that nothing is collected outside it. Do the test yourself before the first badge goes on a worker, with a spare device.

  • Set a shift window, switch the device on, and confirm that at shift end it switches off or stops transmitting.
  • Leave a device powered on overnight in a spare room. Check in the portal whether any location appears after the shift.
  • Pause at a break and confirm no readings arrive during the pause.
  • Simulate a restroom stop by leaving the device behind. Confirm that nothing is reported about the stop beyond what your policy says.
  • Walk the device through a dead zone, then check whether stored readings arrive later with their original times, and whether any off-hours readings are discarded rather than shown.
  • Ask who can see the data and look for the log of views.
  • Ask what happens to location after the retention period. See worker location data retention.

Write down the result of each test. If a vendor cannot show it, treat that as a finding.

What should the policy say about off-hours tracking?

Say four things in plain words: when collection starts, when it stops, what happens at breaks and restrooms, and that off-hours location is not used. Keep it to a short paragraph in the consent form.

  1. The device collects location only during your scheduled work hours.
  2. It stops when your shift ends. If it records anything after that, we discard it.
  3. You may pause it at unpaid meal breaks and leave it behind for restrooms.
  4. We do not use location from outside work hours for any purpose.

For the full consent, see the consent template guide.

Where ZeroBadge fits

ZeroBadge is a company-owned cellular badge the worker wears at work. It is not the worker's phone, and nothing is installed on personal devices. It takes a reading about every 5 minutes during scheduled work hours using GPS, Wi-Fi positioning and cellular positioning. Cellular readings are marked low confidence.

  • Shift end. The badge switches itself off when the scheduled shift ends and stays off until the worker turns it back on.
  • Off-schedule discard. Location readings recorded outside scheduled work hours are discarded automatically by ZeroBadge's system. The exception is a worker who is still clocked in, for example driving back from a jobsite after the shift: that travel is paid work time, so it is kept, for up to 4 hours past the scheduled end.
  • Breaks. Workers can pause location during meal and rest breaks.
  • One-button off. The worker can switch the badge off at any time, and when it is off it does not transmit location.
  • Restrooms. Workers may leave the badge behind before entering a restroom.
  • Records. Every shut-off command and admin view of location detail is recorded in a timestamped log. Raw location is deleted after 30 days.
  • Consent. The worker acknowledges a plain-English disclosure in the worker portal before any location is stored. That is supplemental to the signed written consent each employer should collect itself.

ZeroBadge's tools support compliance. They don't make tracking legal by themselves.

Frequently asked questions

Is it legal to track an employee's location after work?
It is risky and unnecessary. Some state laws and privacy claims turn on whether collection reached off-duty time. Limit collection to paid work hours and test that your system respects the limit.
Can I track workers during their lunch break?
Unpaid meal time is off duty, so location from it is hard to justify. Offer a pause, say what happens in your policy and never use break location for discipline.
Do restroom rules apply outside California?
AB 1331 is a California law that takes effect January 1, 2027. Other states have not been verified here. A policy that lets workers leave the device behind for a restroom is sensible anywhere.
Does the time a worker drives to the jobsite count as work?
Ordinary home-to-work commuting generally does not under federal law, while travel between jobsites during the workday generally does. State law and your agreements can change this.
What if the badge is left on overnight?
That is the case to test. The system should not show or keep location from outside the shift window, and the badge should not stay powered past the end of the shift. Ask your vendor to show it.
Can I use stored readings from a dead zone?
Stored readings that arrive late can help settle hours, but only if they were recorded during the shift. Readings from outside the shift window should be discarded, not reviewed.

Sources

  1. 1.29 CFR 785.38, travel that is all in a day's work · Electronic Code of Federal Regulations
  2. 2.29 U.S.C. section 254, Portal-to-Portal Act exemptions · Legal Information Institute, Cornell Law School
  3. 3.Governor Newsom signs worker protections, September 30, 2026 (includes AB 1331) · Office of the Governor of California
  4. 4.California Penal Code section 637.7 (electronic tracking devices) · California Legislative Information

Get started

See ZeroBadge on your workforce.

Tell us how your crews work today. We will show you a badge-recorded week built from your own jobsites.

What we will walk through

  • 01How the badge records a shift
  • 02Your jobsites as geofences
  • 03The weekly timesheet and approval
  • 04Sending approved hours to payroll