Skip to content

Guide · Oil and gas

Oilfield crew tracking: choosing between an app and a badge

An oilfield crew tracking app records time and location on each hand's phone, so it works only where phones are allowed, charged and in coverage. On many locations at least one of those fails. A worn cellular badge records the shift with no phone, stores reports through coverage gaps and splits hours by well, pad or lease. Neither should go into a classified hazardous area unless it is approved for that location.

Last updated By ZeroBadge

This is general information, not legal advice. Laws differ by state and change over time. Check the primary sources below and talk to an employment lawyer about your situation.

What does an oilfield crew tracker have to handle?

An oilfield tracker has to follow crews that move between remote locations, often several in a day, and turn that into hours your accounting can use. A tool built for one shop floor or one jobsite usually misses at least one of these.

Many locations, far apart
Wellsites, pads, tank batteries, yards and pipeline right-of-way, with long drives between them.
Hours coded the way accounting codes them
By well, lease, pad or AFE, so labor lands on the right cost line without a second spreadsheet.
Drive time kept apart
Travel between locations is usually paid work time and should not be mixed into time on location.
Coverage gaps
Remote locations drop signal. The record has to survive the gap, not end at it.
Phone rules
Many locations restrict personal phones, and some areas ban any electronics not approved for them.

How do a phone app, a badge and a site clock compare in the field?

The difference is what the record depends on. An app depends on the worker's phone. A site clock depends on a device at each location. A badge depends on the worker switching it on.

Three ways to track oilfield crew time, compared on field conditions
Phone appWorn cellular badgeSite clock or kiosk
Needs a personal phoneYesNoNo
Follows a hand between locationsYes, while the phone is on and carriedYes, through the whole shiftNo, only at locations with a clock
Drive time between locationsDepends on the app and on location permissionsClassified as transit, apart from time on locationNot recorded
Coverage gapsDepends on the appReports are stored and uploaded with their original timesDepends on the device
Equipment on each locationNoneNoneA clock and power at every location
Proves who punchedThe phone's owner, if the phone is not sharedNo, it shows where the badge wasSome models check a face or fingerprint

Locations with no coverage for days at a time are a poor fit for any cellular tool, since nothing reaches the office until the device reconnects. For how GPS, Wi-Fi and cell readings differ in precision, see GPS vs Wi-Fi vs cellular location accuracy.

Is drive time between oilfield locations paid?

Usually, yes. Under federal rules, travel from one location to another during the workday is part of the day's work and counts as hours worked (29 CFR 785.38). Ordinary travel from home to the first location and back from the last one is generally not (29 CFR 785.35).

That makes the split between time on location and time on the road a payroll question as well as a job-cost one. A tracker that lumps the drive into the first well it reaches overstates that well's labor and hides the travel. The guide to travel time between job sites covers the exceptions, and the drive time policy guide shows how to write the rule down.

Can a tracking device go into a hazardous area?

Only if it is approved for that classified location. OSHA's electrical standard requires equipment used in hazardous (classified) locations to be approved for the class, division or zone and the gas or vapor present (29 CFR 1910.307). That applies to a phone running a tracking app as much as to a badge.

The ZeroBadge badge is not certified for hazardous locations, including Class I Division 1, ATEX or IECEx zones. Read your location's area classification and your company's electronics rules before any device goes past the boundary.

What should you ask before choosing an oilfield tracking tool?

Take these questions to every vendor, and ask for a trial on your own locations rather than a demo in town.

  • Does it need each hand to carry a phone, and are phones allowed on our locations?
  • What happens to the record when a location loses signal for an hour, and for a day?
  • Can hours be coded by well, lease or AFE using our own names?
  • Is drive time between locations kept separate from time on location?
  • Is the device approved for any classified areas we work in, and if not, where does it stay?
  • Who approves the week, and what reaches payroll?

To see how ZeroBadge handles each of these for oil and gas companies, read the oil and gas page.

Frequently asked questions

Do oilfield hands need a smartphone to be tracked?
Not with a worn badge. The badge has its own cellular connection and needs no app or phone. With a phone app, each hand needs a phone that is allowed on location, charged and in coverage.
What happens to tracked hours when a remote pad has no signal?
A ZeroBadge badge keeps recording, stores its reports and uploads them with their original times when it reconnects, so the day fills in. Locations with no coverage for very long periods are a poor fit, since nothing reaches the office until the badge reconnects.
Can crew hours be split by well or lease?
Yes. Each location is drawn as a boundary on a map and named the way your accounting names it, by well, lease, pad or AFE. On-site time is allocated to the location the badge was at, and timesheets export to CSV, Excel or PDF.
Is the ZeroBadge badge intrinsically safe?
No. The badge is not certified for hazardous locations, including Class I Division 1, ATEX or IECEx zones. Check your site's area classification before it goes into a classified area.

Sources

  1. 1.29 CFR 785.38, Travel that is all in the day's work · eCFR
  2. 2.29 CFR 785.35, Home to work; ordinary situation · eCFR
  3. 3.29 CFR 1910.307, Hazardous (classified) locations · eCFR

Get started

See ZeroBadge on your workforce.

Tell us how your crews work today. We will show you a badge-recorded week built from your own jobsites.

What we will walk through

  • 01How the badge records a shift
  • 02Your jobsites as geofences
  • 03The weekly timesheet and approval
  • 04Sending approved hours to payroll